Hello
I have completet a built of a Ormerod 3d printer, not many problems there
and are now traying to get the software runing.
I have updatet the firmware ( after 3 times ) it is the firmware from 2014-01-16.
The M115 command report correctly, but when i try the M503 I get an error
can't open 0:/sys/config......
I have used the 2gbyte sd-card deliveret, and a 1 gbyte from my phone, bothe have been reformatet fat32.
Have can I check that is is not the sd-card holder that has a defect or somthing
XB70
XB70