Hi everyone, my first post and first attempt at building a 3d printer.. I'm 12.5 hours into the 2 hour build
and on the commissioning section.
I bought my Ormerod last week and have the green printed parts.
I'm using the Pronterface and upgraded firmware and was testing the nozzle heater at 100C and it was fine, next step was the 200C and whilst it was doing this step - I noticed some smoke from the Duet board coming from the corner near the ethernet port. Thought this was strange, so turned it off.
Turned it all back on again and the SD card was dead.
Got another SD card and put the files onto it and back in, powered up and after a few seconds noticed that the smoke was coming from the SD card slot and this SD card was also frazzled too.
Can't really do any more testing until I buy some more SD cards tomorrow.
Has anyone else experienced this problem? or know what's happening?
Is it possible to use it without the SD card files present?