I have Firmware 0.59d-dc42 and reprap 0.8
A problem I have had for a while so it isnt a new problem for me, but I thought I would try and resolve it now.
My config has the following (as shown in the msg section of the Web Interface):
; RepRapPro Ormerod
; Standard configuration G Codes
M111 S0; Debug off
M550 PTimsOrmerod; Set the machine's name
M551 Pxxxxx; Set the password
But whenever I use the Web Interface; at the top left it just shows:- "RepRapPro Ormerod" - and I did not have to use any password.
Any ideas?
Thanks
Tim
Firmware: 059d, Web Interface: 0.8
75mm Diameter Extruder Drive
100mm test model
Filament spool holder and rotating dispenser