Ormerod crash during print

Hi,

i try to print my first own object. Everythink looks fine exept that the printer crashes during the print. It simply stops and doesn't respond to commands any more ( if i reconnect the usb cable, which is not pluged in during the print).
I printed from the SD-Card. I used Slic3r with the Ormerod configs. If i tried it again with the same gcode, it stops at the same position. I tried to slice the object again but i change some options like the fill structure to honeycomb. With the new file
it stops at a different position than before with the older file. The gcode file is about 6MB. I attached a part of the gcode file where the print stops every time.

G1 X103.698 Y120.795 E0.00208
G1 X104.425 Y120.795 E0.01059
G1 X104.425 Y119.390 E0.02045
G1 X102.925 Y119.390 E0.02183
G1 X102.917 Y55.756 E0.92596
G1 F1800.000 E-2.40000  ; Stops around this Command, its close before starting the next layer
G1 Z13.680 F6000.000                          
G1 X112.756 Y62.250 F6000.000
G1 E2.40000 F1800.000
G1 X112.756 Y105.750 E2.17022 F1800
G1 X119.996 Y105.750 E0.36122
G1 X120.274 Y105.772 E0.01388
G1 X120.541 Y105.836 E0.01370
G1 X120.794 Y105.941 E0.01370
G1 X121.028 Y106.084 E0.01370

I updated the firmware and the printer is connected to the UPS of our building.
Any help will be appreciated

Greetings
Alexander

Hi Alexander, it sounds like the printers buffer might have got full of reports to the USB to me.
DC42 would be better to answer this, but if you didn't have M111 S0; Debug off in your config.g file then I'll guess that was it.
The Buffer has a limited size, and when it fills up the printer stops.
It's the reports that come up on the right hand side of Pronterface in the report window.

---

Please send me a PM if you have suggestions, or problems with Big Blue 360.
I won't see comments in threads, as I move around to much.
Working Link to Big Blue 360 Complete

If you are using the RRP 0.65e firmware, then there is a known problem with high extruder feed rates, such as the one that appear in the retraction operation in that gcode. Either reduce the extruder feed rate, or try my 0.65f-dc42 firmware and 0.90 web interface (see separate thread).

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].