Trying to load the new slic3r profile for my ormerod from [
github.com] but as soon as I hit "ok" to load the bundle slic3r just closes. Tried in both v1.1.7 and v1.2.6 experimental (since the beginning of the ini says it was built in 1.2.6)
Has anyone tried loading these? Attached is the picture I sent support and they said I was under extruding (the 1cm cubes in front) and said it's most likely due to them updating some of the settings lately and to use the latest profile in that link to get it fixed. But I'm getting the stated error trying to load it.
Thoughts?