Temp discrepancy: gcode says 210, web interface 230

I am kind of surprised. I rarely check look at the web interface, but as I have finished to rebuilt (third time, i hate cracking plastic of the z axis) i decided to check.
My web interface give 230C while the printing temp is set at 210C. Any clue why? Maybe i have a version with an older resistor?

Edited 1 time(s). Last edit at 08/20/2015 08:54AM by Fpex.

---

----- Making the world smarter @ www.xetal.eu
----- Helping entrepreneurs @ www.fralke.com

It must be a problem with Cura, because the original files form RepRap show the correct temperatures. I guess i better stick with slicer :-)

---

----- Making the world smarter @ www.xetal.eu
----- Helping entrepreneurs @ www.fralke.com

Are you sure you don't have different first layer/other layer speeds configured in Cura?

Edited 1 time(s). Last edit at 08/20/2015 12:02PM by dc42.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

No. I also checked the gcode and i found it normal. This is why i picked one of the original code and saw that it prints correctly. And i can confirm that slic3r also makes proper gcodes. So it is not the printer.
It does also very weird things like a full retract at the end of the print and it does not home as it should. I am going to look at the gcode of these commands as well to see what cura does.

UPDATE: slicer now refuses to home properly and also goes to 230. Bah! I must messed up something when i updated cure and slic3r.

Edited 3 time(s). Last edit at 08/20/2015 01:14PM by Fpex.

---

----- Making the world smarter @ www.xetal.eu
----- Helping entrepreneurs @ www.fralke.com

Damn, it is the G10 M190 change again. I feel stupid.

Edited 1 time(s). Last edit at 08/20/2015 01:36PM by Fpex.

---

----- Making the world smarter @ www.xetal.eu
----- Helping entrepreneurs @ www.fralke.com