slight shear in y seems dependent on layup thickness
Posted by kwikius
|
slight shear in y seems dependent on layup thickness January 16, 2014 11:55AM |
Having solved my SD card problems, I could see my latest print shapping up nicely. However when It was done I noticed a slight problem in the Y direction.: ( the wall is meant to be straight)
If you look at the part from the pther angle you can see the problem starts where the wall gets thin:
I'm wondering if it would improve if I decrease the Yacceleration?
regards
Andy
Ormerod #318
www.zoomworks.org - Free and Open Source Stuff
If you look at the part from the pther angle you can see the problem starts where the wall gets thin:
I'm wondering if it would improve if I decrease the Yacceleration?
regards
Andy
Ormerod #318
www.zoomworks.org - Free and Open Source Stuff
|
Re: slight shear in y seems dependent on layup thickness: SOLVED January 18, 2014 11:46AM |
Quote
iamburny
I had exactly this until i tightened my Y axis Belt, some solutions here [forums.reprap.org]
Excellent! Thankyou! Your device for fixing the y-axis carriage helped me to solve this. I used it as the basis of my solution
The wonky one on the left and the first print with the new belt fastening
regards
Andy
Ormerod #318
www.zoomworks.org - Free and Open Source Stuff
Sorry, only registered users may post in this forum.