Welcome! Log In Create A New Profile

Multiple Extruders

Posted by PaulHam

PaulHam

Multiple Extruders
February 04, 2014 09:09AM

Registered: 10 years ago
Posts: 147

Hi,

Is there a plan for anyone to work on multiple extruders?
I know that the slots are there to hang the extruder stepper motors from, but when could this happen and what is involved?

Reply Quote

dmould

Re: Multiple Extruders
February 04, 2014 10:19AM

Registered: 10 years ago
Posts: 2,472

I can foresee a fair number of snags being hit when that is attempted, with a heavy batch of modifications being required!

Dave
(#106)

Reply Quote

5dala

Re: Multiple Extruders
February 10, 2014 04:26PM

Registered: 10 years ago
Posts: 22

I would instantly be ordering a kit, so how far away is it,a month, a year?
Will they be shipped with a hmm 800w or something PSU)?

I quess you could just order the expansion card for 4 more extruders and hook them up, but I have no idea as to how much work remains before releasing firmware for this setup..

But soon, i hope grinning smiley

Reply Quote

dc42

Re: Multiple Extruders
February 10, 2014 05:25PM

Registered: 10 years ago
Posts: 14,672

Would you need a bigger PSU? The extruder motors don't consume very much power, and I imagine the print head would be similar to the current one but with three nozzles in a single heated block, so there would still be only one heater. This is assuming that all 3 filaments extrude at the same temperature. If you wanted separate heated blocks, then you would still need no more than 100W additional power.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

adsoftware

Re: Multiple Extruders
February 10, 2014 06:39PM

Registered: 10 years ago
Posts: 23

I think, some work is underway for multi-colour, but I'm not sure how this would be mounted.

Reply Quote

T3P3

Re: Multiple Extruders
February 12, 2014 06:52PM

Registered: 12 years ago
Posts: 177

The Duet was designed with an expansion board in mind, we are using a 4 channel expansion board right now but different power stepper drivers and numbers of channels is possible.

Cheers

Tony