Set Z-axis manually February 07, 2014 11:41AM |
Registered: 10 years ago Posts: 18 |
Re: Set Z-axis manually February 07, 2014 11:57AM |
Registered: 10 years ago Posts: 14,684 |
Re: Set Z-axis manually February 07, 2014 12:16PM |
Registered: 10 years ago Posts: 265 |
Re: Set Z-axis manually February 07, 2014 06:23PM |
Registered: 10 years ago Posts: 14,684 |
Quote
lvperlo
Why? I just told the machine it was at Z=0 and it did not move since ...
It appears that the bed compensation creates the Z=-0.312586 at pos X100 Y100, because if I omit the G32 in the above procedure it works as expected.
Re: Set Z-axis manually February 07, 2014 07:00PM |
Registered: 10 years ago Posts: 33 |
Re: Set Z-axis manually February 07, 2014 07:09PM |
Registered: 10 years ago Posts: 14,684 |
Re: Set Z-axis manually February 07, 2014 07:13PM |
Registered: 10 years ago Posts: 18 |
Re: Set Z-axis manually February 07, 2014 07:20PM |
Registered: 10 years ago Posts: 33 |