Welcome! Log In Create A New Profile

Advanced

Help: Setting Z Heights in config.g will cause X to crash to the wall

Posted by antlvk 
Forum List Message List New Topic
antlvk
Help: Setting Z Heights in config.g will cause X to crash to the wall
March 08, 2014 06:59AM
When ever i put this
G31 Z2.59 P656 to config.g it will crash my head to the x wall. anyone?
Reply Quote
antlvk
Re: Help: Setting Z Heights in config.g will cause X to crash to the wall
March 08, 2014 07:12AM
NVM found the problem
Reply Quote
dc42
Re: Help: Setting Z Heights in config.g will cause X to crash to the wall
March 08, 2014 08:04AM
I guess you needed to put a piece of white tape on the X homing tab?


Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Reply Quote
antlvk
Re: Help: Setting Z Heights in config.g will cause X to crash to the wall
March 08, 2014 08:48AM
yup my white paper flew off that's why it crashed.
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login