Printer wont start print even temperature is met

Printer wont start print even temperature is met, weird. in repetier-host temperature is not met, but in web the temperature is met.


16:23:32.159 : serial: N35 G21 *12
16:23:32.161 : serial: N36 G90 *5
16:23:32.161 : N42 M117 ETE 1h 04m 29s *46
16:23:32.162 : serial: N37 M83 *12
16:23:32.163 : N43 M116 *50
16:23:32.163 : serial: N38 M140 S110 *126
16:23:32.164 : N44 G10 P0 S205 R0 *78
16:23:32.165 : serial: N39 G1 Z5 F200 *41
16:23:32.166 : serial: N40 G1 X2 Y50 F2000 *110
16:23:32.167 : N45 T0 *43
16:23:32.167 : N46 M116 *55
16:23:32.167 : serial: N41 M105 *50
16:23:32.169 : N47 M109 S230 *122
16:23:32.180 : N48 G90 *12
16:23:32.180 : serial: N42 M117 ETE 1h 04m 29s *46
16:23:32.181 : invalid M Code: M117 ETE 1h 04m 29s
16:23:32.181 : serial: N43 M116 *50
16:23:32.181 : N49 M83 *5

Edited 2 time(s). Last edit at 03/24/2014 04:35AM by antlvk.

no one has same problem?

Perhaps Repetier is waiting for a response to the M117 command, which is will never get because the Duet firmware doesn't support that command.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Where can i disable this m117 code? can't frin it in slic3r or repetier

Are you using the Ormerod slic3r settings files? If not then perhaps the M117 command is in the custom gcode section of the printer settings in slic3r.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

New founding. I disabled the M117 code. sent by the program.

Edited 1 time(s). Last edit at 03/25/2014 06:37AM by antlvk.