Welcome! Log In Create A New Profile

Advanced

New firmware 058-dc42 and web interface 0.69

Posted by dc42 
Forum List Message List New Topic
Rothestar
Re: New firmware 058-dc42 and web interface 0.69
April 25, 2014 02:28PM
Got ny first snowman, will get a new SD card tomorrow... Any brand I should prefer ?

Henrik
Reply Quote
dc42
Re: New firmware 058-dc42 and web interface 0.69
April 25, 2014 02:53PM
Quote
Rothestar
Got ny first snowman, will get a new SD card tomorrow... Any brand I should prefer ?

Henrik

If you go for a class 10 then any brand should do. I suggest choosing a low-capacity one. I use a Maplin own-brand 4Gb Class 10.


Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Reply Quote
Rothestar
Re: New firmware 058-dc42 and web interface 0.69
April 26, 2014 11:41AM
Got the new SD card, upgraded the firmware and the web interface... now pronterface connects, made a print. Im happy...


Henrik

Back to printing..
Reply Quote
gdwinslow
Re: New firmware 058-dc42 and web interface 0.69
September 30, 2014 12:47AM
Not sure weather this is the right place or knot. But i had a question on the v1.02 web interface, using the 0.78 FW. In the reprap.htm file, should this line Below:
vertical-aligb
be
vertical-align ?

Edited 1 time(s). Last edit at 09/30/2014 12:49AM by gdwinslow.
Reply Quote
jstck
Re: New firmware 058-dc42 and web interface 0.69
September 30, 2014 02:17AM
No, this isn't the right place (this thread is for the old 058 series, you're on 078), and yes it should be vertical-align.
Reply Quote
Page 3 of 3    Pages: Previous123
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login