I have the standard z probe and its been working ok for me recently, but today i have changed my z gears to iamburnys gears turned on the printer and the Z probe is indicating from 1015 - 1020
This means i cannot home the X axis.
I have checked the plug on the probe circuit and it is pluged in, and i have checked the wire going into the top row of the duet and that is pluged in too.
any ideas?
EDIT - as i was writing this i thought i should check the 2 other wires from the z probe circuit, and yes, they had come unpluged!
all sorted
Edited 1 time(s). Last edit at 04/29/2014 07:18AM by PaulHam.