Hello everyone,

[reprappro.com]

this looks like a new fan duct design? Anybody knows where i can find the stl for that?

Best regards,
Andreas

Yes, it does look like a new fan duct design. I find it odd that the photo shows the pins for the 6-pin connector crimped on already, but not fitted into the shell.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

While we are on the subject on fan ducts, is it necessary to have a fan duct along with the heatsink duct?
Ive been printing without the fan duct all the time.

Will the fan duct add to something? Quality? Filament cooling?



Edited 1 time(s). Last edit at 07/15/2014 03:57PM by Sardi.

The fan duct is needed for filament cooling when printing with PLA. Without it, you will not get good bridges.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

I have been printing without the fan duct since I installed your sensor kit. I guess I didnt print anything that big that requires bridges. But I will install it just for future case.