Printer not really print in center. Can't fully utilized the bed. July 30, 2014 12:34PM |
Registered: 10 years ago Posts: 147 |
Re: Printer not really print in center. Can't fully utilized the bed. July 30, 2014 01:56PM |
Registered: 10 years ago Posts: 14,672 |
Re: Printer not really print in center. Can't fully utilized the bed. July 30, 2014 04:38PM |
Registered: 10 years ago Posts: 378 |
Re: Printer not really print in center. Can't fully utilized the bed. July 30, 2014 10:47PM |
Registered: 10 years ago Posts: 147 |
Re: Printer not really print in center. Can't fully utilized the bed. July 31, 2014 02:23AM |
Registered: 10 years ago Posts: 147 |
Re: Printer not really print in center. Can't fully utilized the bed. July 31, 2014 04:49AM |
Registered: 10 years ago Posts: 1,230 |
Quote
antlvk
where can i find guides for this?
Quote
reprap wiki
G92: Set Position
Example: G92 X10 E90
Allows programming of absolute zero point, by reseting the current position to the values specified. This would set the machine's X coordinate to 10, and the extrude coordinate to 90. No physical motion will occur.
A G92 without coordinates will reset all axes to zero.
Re: Printer not really print in center. Can't fully utilized the bed. July 31, 2014 08:16AM |
Registered: 10 years ago Posts: 378 |
M564 S0 ;Temporarily allow duet to think outside the box G1 X-17 Y212 ;Go to whatever coordinates put the head over the top-left corner of the bed G92 X0 Y200 ;Define that position to be (0,200), which is the normal boundary M564 S1 ;Reenable range safeties
Re: Printer not really print in center. Can't fully utilized the bed. July 31, 2014 08:16AM |
Registered: 10 years ago Posts: 378 |
Re: Printer not really print in center. Can't fully utilized the bed. July 31, 2014 10:19PM |
Registered: 10 years ago Posts: 147 |
Re: Printer not really print in center. Can't fully utilized the bed. August 01, 2014 02:34AM |
Registered: 10 years ago Posts: 378 |
Quote
antlvk
basiucally X zero position wont be at the parking spot right?
Re: Printer not really print in center. Can't fully utilized the bed. August 22, 2014 02:35AM |
Registered: 10 years ago Posts: 147 |
Re: Printer not really print in center. Can't fully utilized the bed. August 22, 2014 08:03AM |
Registered: 10 years ago Posts: 378 |
Re: Printer not really print in center. Can't fully utilized the bed. August 22, 2014 09:06AM |
Registered: 12 years ago Posts: 1,611 |
Re: Printer not really print in center. Can't fully utilized the bed. August 25, 2014 06:39AM |
Registered: 10 years ago Posts: 147 |