After update filrwamre to 0.78r disaster happen, help

Now i cant start print, when head temperature met i just wont start and head become not active and temp are going down after that.

i have T1 code. Weird. Help

Do you have the correct M563 tool definition command in config.g ?

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

deleted*

M111 S0 ; Debug off
M550 PAnthony's Ormerod 3D Printer ; Machine name (can be anything you like)
M551 Preprap ; Machine password (currently not used)
M540 P0xBE:0xEF:0xDE:0xAD:0xFE:0xED ; MAC Address
M552 P192.168.1.14 ; IP address
M553 P255.255.255.0 ; Netmask
M554 P192.168.1.1 ; Gateway
M555 P2 ; Set output to look like Marlin
G21 ; Work in millimetres
G90 ; Send absolute corrdinates...
M83 ; ...but relative extruder moves
M906 X800 Y1000 Z800 E800 ; Set motor currents (mA)
M563 P1 D0 H1 ; Define tool 1
G10 P1 S0 R0 ; Set tool 1 operating and standby temperatures
M92 E433 ; Set extruder steps per mm
M558 P1 ; Use an unmodulated Z probe
G31 Z1.22 P656 ; Set the probe height and threshold
M557 P0 X65 Y10 ; Four...
M557 P1 X65 Y160 ; ...probe points...
M557 P2 X200 Y160 ; ...for bed...
M557 P3 X200 Y10 ; ...levelling
M556 S78 X0 Y0 Z0 ; Put your axis compensation here
M201 X800 Y800 Z15 E1000 ; Accelerations (mm/s^2)
M203 X15000 Y15000 Z60 E3600 ; Maximum speeds (mm/min)
M566 X800 Y800 Z30 E20 ; Minimum speeds mm/minute

Edited 1 time(s). Last edit at 09/14/2014 11:57PM by antlvk.