Welcome! Log In Create A New Profile

Hotend stops heating 2 degrees before reaching set point

Posted by gclair

gclair

Hotend stops heating 2 degrees before reaching set point
October 04, 2014 03:45PM

Registered: 10 years ago
Posts: 1

I am using ramps 1.4 and arduino mega 2560. The bed heats up, hotend starts to heat but stops 2 degrees before 205 setpoint.

Any help would be appreciated.

Thank you,
Gary Clair

Reply Quote

dc42

Re: Hotend stops heating 2 degrees before reaching set point
October 04, 2014 06:06PM

Registered: 11 years ago
Posts: 14,686

Did you mean to post that question to this section of the forum? The Ormerod works with Duet electronics, not RAMPS/Arduino.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].