Ormerod 2 With Duet, Hot end wont heat up with Ethernet...

So, here's my issue...

Ethernet works, and I can get to the web-gui no problems, Printing works over USB no problem. I plug in just Ethernet or even USB and Ethernet, nothing... The thermister on the hot end reports back properly, but, it won't heat up, at all. The web interface gives me nothing to go on, and pronterface says "Setting temperature: no tool selected.", but it ONLY says that if ethernet is up.

Any ideas what could cause this?

My guess is that the web interface you are using is not compatible with the firmware and config.g file. Which firmware and web interface versions are they?

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].