DC42, Bed leveling request March 27, 2015 02:34PM |
Registered: 9 years ago Posts: 62 |
Re: DC42, Bed leveling request March 27, 2015 03:26PM |
Registered: 10 years ago Posts: 14,672 |
Re: DC42, Bed leveling request March 27, 2015 08:56PM |
Registered: 9 years ago Posts: 62 |
Re: DC42, Bed leveling request March 27, 2015 11:47PM |
Registered: 9 years ago Posts: 177 |
Re: DC42, Bed leveling request March 31, 2015 04:57PM |
Registered: 10 years ago Posts: 51 |
Re: DC42, Bed leveling request April 01, 2015 03:57AM |
Registered: 9 years ago Posts: 62 |
Re: DC42, Bed leveling request April 01, 2015 07:18AM |
Registered: 10 years ago Posts: 2,472 |
Quote
Yella3D
Shadow.
I had not thought about a raft for this, however the use of a raft may not be ideal, but it would ensure that the print is parallel from top to bottom.
I think we are only talking about a +/-.2mm difference, anymore than that, the bed should need mechanical leveling.
Pandionx.
That too is an interesting idea, however I feel as it is the printer that is at fault, it would be better to have a software solution embedded in the printer as opposed to the slicer.
For example, multiple build plates with different surface variables could be used without the need to re-slice a model for each build plate.
I will eventually have numbered build plates and corresponding setbed files on the SD card.
Re: DC42, Bed leveling request April 01, 2015 03:27PM |
Registered: 10 years ago Posts: 51 |