Z Probe losing calibration May 22, 2015 04:48AM |
Registered: 8 years ago Posts: 6 |
Re: Z Probe losing calibration May 22, 2015 06:09AM |
Registered: 10 years ago Posts: 14,672 |
Re: Z Probe losing calibration May 22, 2015 08:41AM |
Registered: 10 years ago Posts: 2,472 |
Re: Z Probe losing calibration May 22, 2015 10:19AM |
Registered: 10 years ago Posts: 1,230 |
Re: Z Probe losing calibration May 22, 2015 11:58AM |
Registered: 9 years ago Posts: 7 |
Re: Z Probe losing calibration May 22, 2015 12:05PM |
Registered: 10 years ago Posts: 14,672 |
Quote
helix
Are any of DC42's chips available? where would i get one, I want ten!! no seriously...
Re: Z Probe losing calibration May 22, 2015 02:50PM |
Registered: 11 years ago Posts: 103 |
Re: Z Probe losing calibration May 23, 2015 06:39PM |
Registered: 10 years ago Posts: 300 |
Re: Z Probe losing calibration May 25, 2015 01:14AM |
Registered: 8 years ago Posts: 6 |
Re: Z Probe losing calibration May 25, 2015 12:40PM |
Registered: 9 years ago Posts: 39 |
Re: Z Probe losing calibration May 25, 2015 01:57PM |
Registered: 9 years ago Posts: 638 |
Re: Z Probe losing calibration May 25, 2015 02:32PM |
Registered: 10 years ago Posts: 300 |
Quote
rjmusto
I reckon I am seeing the same problem with a new Ormerod 2. After a few prints, the nozzle sits a fraction too low and smears the extrusion rather than leaving a neat bead of filament. Recalibrating the Z Probe sorts it for a while, then the same thing happens.
Think I need one of your boards too DC42!
Ralph
Re: Z Probe losing calibration May 25, 2015 03:04PM |
Registered: 10 years ago Posts: 14,672 |
Re: Z Probe losing calibration June 10, 2015 06:25AM |
Registered: 9 years ago Posts: 39 |