Z Home Question May 25, 2015 07:23AM |
Registered: 10 years ago Posts: 2 |
Re: Z Home Question May 25, 2015 07:29AM |
Registered: 11 years ago Posts: 14,685 |
Quote
xxilim
However, when I start a print X, Y then Z all home, but when Z homes it drops down gets close the bed as expected, then comes back up, then back down but maybe 0.1 or 0.2 higher than where home should be, then prints from there?
Re: Z Home Question May 25, 2015 07:49AM |
Registered: 10 years ago Posts: 2 |
Re: Z Home Question May 25, 2015 08:40AM |
Registered: 11 years ago Posts: 1,230 |
Quote
xxilim
...Is there any way to reduce how high it lifts on the first layer? I feel like it's to high and that's causing the first layer to release?...
Re: Z Home Question May 25, 2015 08:40AM |
Registered: 11 years ago Posts: 14,685 |
Quote
xxilim
Oh... I though it started at Z0thanks DC42
Is there any way to reduce how high it lifts on the first layer? I feel like it's to high and that's causing the first layer to release?
Re: Z Home Question May 25, 2015 09:02AM |
Registered: 11 years ago Posts: 2,472 |