Welcome! Log In Create A New Profile


Duet Shield Power Connections

Posted by HarveyC 
Duet Shield Power Connections
June 07, 2015 06:29AM
Am I correct in beileving that the power for the Duet Shield is 12V and is taken from the spare connector block on the 5v Regulator Board?? As far as I can see, the instructions for the multi extruder upgrade do not mention the power connections at all.

Re: Duet Shield Power Connections
June 08, 2015 08:16AM
Hi Harvey

Yes. The pictures here show it connected: [reprappro.com]
Thanks for pointing out that this isn't mentioned, I'll update the text to describe how the power should be connected.

RepRapPro tech support

Edited 1 time(s). Last edit at 06/08/2015 10:06AM by droftarts.
Re: Duet Shield Power Connections
June 08, 2015 10:48AM
Thanks Ian, It's for the Mendel 3 upgrade actually, but there does not appear any other place to post this type of query about Duet (perhaps there should be a separate section?). I found the picture after I made the post.


(Harry ... Hungerford)
Sorry, only registered users may post in this forum.

Click here to login