Colorfabb XT-copolyester

Can find mentions of this filament on this forum and a couple of vids on youtube, but wondered if anyone had actually used it in an Ormerod. It appears to be stiffer/tougher than PLA I think and looks like it cools or glasses faster so copes with small overhangs much better.
Was going to buy a sample but with 10 euros shipping for a 50 gram sample might as well buy a reel!

[colorfabb.com] no affiliation btw.

Thanks for any feedback

Jon

Edited 1 time(s). Last edit at 06/10/2015 09:35AM by Firefox3D.

XT is more like ABS then pla(it is not bio plastic) but with less warping problems it also prints at 240+C. I've heard good things abaut it but i havent tried it yet. Colorfabb is quite expensive for me

Edited 1 time(s). Last edit at 06/10/2015 01:36PM by Darathy.