Welcome! Log In Create A New Profile

E3D V6

Posted by Darathy

Treito

Re: E3D V6
August 29, 2015 04:01PM

Registered: 12 years ago
Posts: 1,699

I am sorry but this would be a different problem. Strings are like a spider web and they have different sources than blobs.

Slicer: Simplify3D 4.0; sometimes CraftWare 1.14 or Cura 2.7
Delta with Duet-WiFi, FW: 1.20.1RC2; mini-sensor board by dc42 for auto-leveling
Ormerod common modifications: Mini-sensor board by dc42, aluminum X-arm, 0.4 mm nozzle E3D like, 2nd fan, Z stepper nut M5 x 15, Herringbone gears, Z-axis bearing at top, spring loaded extruder with pneumatic fitting, Y belt axis tensioner
Ormerod 2: FW: 1.19-dc42 on Duet-WiFi. own build, modifications: GT2-belts, silicone heat-bed, different motors and so on. Printed parts: bed support, (PSU holder) and Y-feet.
Ormerod 1: FW: 1.15c-dc42 on 1k Duet-Board. Modifications: Aluminium bed-support, (nearly) all parts reprinted in PLA/ ABS, and so on.

Reply Quote

markdoll01

Re: E3D V6
September 09, 2015 12:52PM

Registered: 11 years ago
Posts: 14

Hi,

Received my E3D v6 about a week ago and so far I am very happy with it. Using S3D and getting much better results than with the stock hotend - much less blobs .

I did a mix of two hot existing hot ends, the one I found on the forum and the other one was on Thingiverse for mounting the E3D v6 and so far so good smileys with beer

Both PLA and ABS print fine.

[www.thingiverse.com]

Reply Quote

dapsaille

Re: E3D V6
December 15, 2015 12:00PM

Registered: 11 years ago
Posts: 17

Does anyone have a stl for hotend mount for e3dv6 with dc42's hot end board V2 support ?

(i'm not really good in 3d software) grinning smiley

Reply Quote

Darathy

Re: E3D V6
December 15, 2015 02:49PM

Registered: 11 years ago
Posts: 638

this is the one i was using when i used E3D : [forums.reprap.org]

BUT you will lose some build hight since the hotend is positioned lower and i think some in X and Y direction.

tip: If you are gona use E3D use 5-7mm(there is risk) retraction if you will get blobs ,if not use 2mm as E3D suggests.

Edited 1 time(s). Last edit at 12/15/2015 02:57PM by Darathy.

Reply Quote

dapsaille

Re: E3D V6
December 15, 2015 03:06PM

Registered: 11 years ago
Posts: 17

that's perfect

thanks a lot smileys with beer

Reply Quote

Page 3 of 3 Pages: