Welcome! Log In Create A New Profile


Quick-set nozzle C-C

Posted by fotomas 
Quick-set nozzle C-C
December 19, 2015 03:46PM
What is the C-C measurement of the nozzles in the quick-set nozzle cooling block?

Edited 1 time(s). Last edit at 12/19/2015 03:50PM by fotomas.
Re: Quick-set nozzle C-C
December 20, 2015 11:38AM
I measured mine at 19mm, then I printed a test using both nozzles and resultant print looked exactly right to me.

I didn't find anywhere where it gave a measurement.


Re: Quick-set nozzle C-C
December 20, 2015 12:54PM
My tests have been closing in on 19 mm too. I have been giving this some thought and there could be some backlash involved too. Moving to a corner of the bed and back again can not be beneficial if there is a tendency to backlash.

There will be a lot of traffic cones in the end;

(I tried to find a CAD drawing of the cooling block at github but I was lost when there is no obvious naming scheme of the files.)
Sorry, only registered users may post in this forum.

Click here to login