Fan mount for dc42 board with 2nd cooling fan
Posted by unstable
|
Fan mount for dc42 board with 2nd cooling fan February 08, 2016 04:16PM |
Registered: 10 years ago Posts: 34 |
I know there are a few designs for the fan/hot-end mount with DC42's sensor board, but does anyone have something that makes use of a second fan for cooling? I have 2 * 40mm x 10mm fans, and would like to use them to increase cooling on the parts if I could. Ideally I want 360deg cooling.
|
Re: Fan mount for dc42 board with 2nd cooling fan February 08, 2016 05:01PM |
Registered: 11 years ago Posts: 638 |
you can use my design if u like [www.thingiverse.com]
But it does not have 360 cooling ,it uses fan duct for ormerod.
Edited 1 time(s). Last edit at 02/08/2016 05:01PM by Darathy.
But it does not have 360 cooling ,it uses fan duct for ormerod.
Edited 1 time(s). Last edit at 02/08/2016 05:01PM by Darathy.
|
Re: Fan mount for dc42 board with 2nd cooling fan February 08, 2016 05:04PM |
Registered: 10 years ago Posts: 34 |
Thanks Darathy. I had that design before changing to DC42's board, but wasn't happy with the fan duct as it often caught on the print. I like the new design from dc42 (Github) but want something that can use both fans, the one for the cold end (redirected from the heat sink) and the other fan controlled via gcode.
|
Re: Fan mount for dc42 board with 2nd cooling fan February 08, 2016 05:08PM |
Registered: 11 years ago Posts: 638 |
|
Re: Fan mount for dc42 board with 2nd cooling fan February 11, 2016 01:06AM |
Registered: 11 years ago Posts: 191 |
I use dc42 dual nozzle sensor board.
I use this for cooling:[www.thingiverse.com]
With two modifications That I made my self:
Tighter fit to the ormerod: [www.thingiverse.com]
And a duck-like duct:
[www.thingiverse.com]
I use a bladeserver 5v fan that runs on the 12v fan ot connection on Duet 0.6. I set it at 15-20% (set in slic3r). Cools very, very well.
I use this for cooling:[www.thingiverse.com]
With two modifications That I made my self:
Tighter fit to the ormerod: [www.thingiverse.com]
And a duck-like duct:
[www.thingiverse.com]
I use a bladeserver 5v fan that runs on the 12v fan ot connection on Duet 0.6. I set it at 15-20% (set in slic3r). Cools very, very well.
Sorry, only registered users may post in this forum.