|
Ormerod 384 February 13, 2016 05:46PM |
Hi guys,
in the process of building my first ever 3D printer! I'm at the heat bed assembly stage and have run into some trouble...
In the heated bed assembly documentation it says I need a 10k thermistor, 2 way female housing and 2 male crimp terminals.
Instead I have what was shipped with mine - 100k thermistor, 2x3-way female housing and 160mm of thermistor wiring. Has anyone had this issue before?
Many thanks from a newbie,
Tom
in the process of building my first ever 3D printer! I'm at the heat bed assembly stage and have run into some trouble...
In the heated bed assembly documentation it says I need a 10k thermistor, 2 way female housing and 2 male crimp terminals.
Instead I have what was shipped with mine - 100k thermistor, 2x3-way female housing and 160mm of thermistor wiring. Has anyone had this issue before?
Many thanks from a newbie,
Tom
|
Re: Ormerod 384 February 13, 2016 07:55PM |
Disregard, had a bad case of check the component bags 
Sorry, only registered users may post in this forum.