Welcome! Log In Create A New Profile


New arm processor

Posted by stibo01 
New arm processor
December 10, 2016 07:56AM

my duet board was blown up a few years ago ( arm processor was very hot ). Last week I replaced the arm processor.(arm3x8e )
Who can help me to restart the duet board?

How can I place the boot in the processor and wich boot ?

thanks in advance..
Re: New arm processor
December 10, 2016 10:49AM
The board isn't visible in the device manager.
The power is ok. All leds are ok.
Perhaps there is still a fault in the board or is this only a software problem ?
Re: New arm processor
December 10, 2016 06:13PM
If the processor is correctly installed and getting 3.3V power, then it should show up as Bossa Port in Device Manager. You might possibly need to press the Erase and then the Reset button The bootloader is in the ROM of the processor.

Edited 1 time(s). Last edit at 12/10/2016 06:15PM by dc42.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Re: New arm processor
December 14, 2016 12:57AM
The processor was indeed correctly installed and the power was ok.
The problem was the USB cable. There where no datawire connection in the cable , only power connection.
I think that this cable was an old power cable from a cellphone ?

So now we can start again.

Thanks for the help.

Re: New arm processor
December 14, 2016 10:54AM
Yes, I've been caught by power-only cables before!

Re: New arm processor
January 08, 2017 06:40AM
I have a 0.6 with the same problem. It would be great to have a spare. Where did you get the processor from? Was it difficult to replace?
Sorry, only registered users may post in this forum.

Click here to login