Re: 2 issues March 04, 2017 12:59PM |
Registered: 10 years ago Posts: 776 |
Quote
Sardi
EDIT: I have raised the Z to +40, when I lowered it back down the 0.0 was +0.8 from the bed.
Any ideas what can cause this?
Re: 2 issues March 05, 2017 04:56AM |
Registered: 10 years ago Posts: 466 |
Re: 2 issues March 05, 2017 10:03AM |
Registered: 10 years ago Posts: 776 |
Re: 2 issues March 05, 2017 11:17AM |
Registered: 10 years ago Posts: 466 |
Re: 2 issues March 05, 2017 11:58AM |
Registered: 10 years ago Posts: 780 |
Re: 2 issues March 05, 2017 12:37PM |
Registered: 10 years ago Posts: 466 |
Re: 2 issues March 06, 2017 06:59AM |
Registered: 10 years ago Posts: 2,472 |
Re: 2 issues March 09, 2017 04:19AM |
Registered: 10 years ago Posts: 466 |
Quote
Sardi
2) I set Z0.0 at x0y100. I do the print. When I want to do a second print, the x0y100 is almost never at 0.0, either +/- 0.1, I must re-check every time before a print.
EDIT: I have raised the Z to +40, when I lowered it back down the 0.0 was +0.8 from the bed.
Any ideas what can cause this?
M201 X800 Y800 Z15 E1000 ; Accelerations (mm/s^2) M203 X15000 Y15000 Z100 E3600 ; Maximum speeds (mm/min) M566 X600 Y600 Z30 E20 ; Minimum speeds mm/minute
Re: 2 issues March 09, 2017 10:48AM |
Registered: 10 years ago Posts: 14,672 |
Quote
Sardi
2) I set Z0.0 at x0y100. I do the print. When I want to do a second print, the x0y100 is almost never at 0.0, either +/- 0.1, I must re-check every time before a print.
EDIT: I have raised the Z to +40, when I lowered it back down the 0.0 was +0.8 from the bed.
Any ideas what can cause this?
Re: 2 issues March 26, 2017 08:34AM |
Registered: 10 years ago Posts: 466 |
Quote
Sardi
2) I set Z0.0 at x0y100. I do the print. When I want to do a second print, the x0y100 is almost never at 0.0, either +/- 0.1, I must re-check every time before a print.
Re: 2 issues March 27, 2017 01:29PM |
Registered: 10 years ago Posts: 2,472 |
Re: 2 issues March 27, 2017 04:44PM |
Registered: 10 years ago Posts: 466 |