RRF configuration tool help - X and Y location homeall
Posted by Ecko
|
RRF configuration tool help - X and Y location homeall November 18, 2017 02:27PM |
Registered: 10 years ago Posts: 54 |
I just upgraded to 1.19 from a previos version and noticed and cant get the x homing right. The sensor hovers just at the end of the bed instead on X55 as it should.
Is there a way of inputting the bed homing locations as i used to - this is all very different from what i was used to.
Thanks guys.
Is there a way of inputting the bed homing locations as i used to - this is all very different from what i was used to.
Thanks guys.
|
Re: RRF configuration tool help - X and Y location homeall November 18, 2017 02:39PM |
Registered: 10 years ago Posts: 54 |
i initialy thought i broke my ir sensor so i bought an DC42's sensor as an upgrade - it hasnt arrived yet, but i am looking forward to it.
My old sensor wasnt broken - the sys code does not have my bed positioning - but i dont know exactly where to put it as all my modifications still result in the x axis still wanting to home outside the bed (X15) instead of X55 or something like that...
Please help.
My old sensor wasnt broken - the sys code does not have my bed positioning - but i dont know exactly where to put it as all my modifications still result in the x axis still wanting to home outside the bed (X15) instead of X55 or something like that...
Please help.
|
Re: RRF configuration tool help - X and Y location homeall November 18, 2017 04:12PM |
Registered: 10 years ago Posts: 14,685 |
On the Ormerod, during homing the proximity sensor triggers with the nozzle well off the bed. Measure how far off that is, then set the X parameter in the M208 S1 command to that negative X value. For example, if the sensor triggers when the nozzle is 19mm off the edge of the bed, use X-19 in the M208 S1 command.
Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod
Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod
Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
|
Re: RRF configuration tool help - X and Y location homeall November 18, 2017 07:46PM |
Registered: 7 years ago Posts: 70 |
Sorry, only registered users may post in this forum.