Welcome! Log In Create A New Profile

Printer Home all after print a has finished

OldOrmerod1

Printer Home all after print a has finished
April 22, 2018 04:37AM

Registered: 6 years ago
Posts: 2

Hi all
i got an issue with my old ormerod 1

After it finish a print the printer homes all and if its a large print the hot end crashes though the print.

Iv updated the firmware to 1.09

Is their any gcode to fix this

thanks

Reply Quote

dc42

Re: Printer Home all after print a has finished
April 22, 2018 05:32AM

Registered: 10 years ago
Posts: 14,682

It sounds like either your slicer end gcode or your stop.g file has a G28 command in it.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

OldOrmerod1

Re: Printer Home all after print a has finished
April 23, 2018 07:16AM

Registered: 6 years ago
Posts: 2

i had a look at stop.g file and there was nothing in it and the slicer im using is cure and i edited it and checked their was no G28 in there.