Ormerods to help the key workers
Posted by kwikius
|
Ormerods to help the key workers May 03, 2020 11:35AM |
Hi All,
Long time since I was here. My Old Ormerod has been working well for the last few years( just prototyping mainly rather than day in day out), though I havent followed most of the upgrades, still using Pronterface! (though I did upgrade to dc42's firmware, since it does curves much more elegantly). One day I will get around to upgrading everything, but meanwhile I decided to try helping out printing some PPE masks for the NHS.
Here is a link in case you havent seen it.
[www.rs-online.com]
The standards of printing required are quite high to make sure surfaces are clean and structure is sound so I thought it would appeal to users here
Anyway, it is good to see the Ormerod forum is still busy!
regards
Andy Little
Ormerod #318
www.zoomworks.org - Free and Open Source Stuff
Long time since I was here. My Old Ormerod has been working well for the last few years( just prototyping mainly rather than day in day out), though I havent followed most of the upgrades, still using Pronterface! (though I did upgrade to dc42's firmware, since it does curves much more elegantly). One day I will get around to upgrading everything, but meanwhile I decided to try helping out printing some PPE masks for the NHS.
Here is a link in case you havent seen it.
[www.rs-online.com]
The standards of printing required are quite high to make sure surfaces are clean and structure is sound so I thought it would appeal to users here
Anyway, it is good to see the Ormerod forum is still busy!
regards
Andy Little
Ormerod #318
www.zoomworks.org - Free and Open Source Stuff
Sorry, only registered users may post in this forum.