Mate I'm in NSW and might be able to help.
If you haven't got it sorted already and are able to forward the files through to me, I'll most likely be able to do them at a reasonable price.
I've got a very good Australian made PETG in red that I can print to a high standard if that's of interest.
Just PM me if you like.
Quote
robbycar
I have not used my Ormerod for a few years.
I dusted it off, cleaned the surface rust off and lubricated the slide rods, but found a couple of cracks on the printed parts.
Is there anywhere I can buy a complete set of printed parts?
I spent the past hour looking on the net without success.
Rob
Sydney, Australia