Welcome! Log In Create A New Profile

Advanced

Controlling 2 ormerods on 1 laptop

Posted by Sardi 
Controlling 2 ormerods on 1 laptop
May 15, 2021 02:37PM
Is that possible?

I own an Ormerod 1 that I control via web interface on my laptop, and I have recently purchased an used Ormerod 2..

Is it possible to somehow control both of them on 1 laptop via router or something?
Re: Controlling 2 ormerods on 1 laptop
May 16, 2021 02:09AM
Yes, just configure them to have different MAC addresses (M540) and different IP addresses (M552) and use 2 tabs in your browser.

Edited 1 time(s). Last edit at 05/16/2021 02:12AM by dc42.



Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Re: Controlling 2 ormerods on 1 laptop
May 16, 2021 04:43AM
Thanks DC, will do that as soon as I finish printing the replacement parts for the 02.
Re: Controlling 2 ormerods on 1 laptop
September 28, 2021 10:46AM
I have changed the MAC and IP address on my Ormerod 2, but it doesnt want to finish loading the page.

They are both connected to a router, and Im controlling Ormerod 1 without any issues, but O2 page just keeps loading.

reprap2loading



EDIT: somehow managed to click "Connect" and get it to "Retrying" but that is as far as it goes.

reprap2loading2

Re: Controlling 2 ormerods on 1 laptop
October 02, 2021 05:18AM
Sorted.

Upgraded firmware to 1.18.1 and web interface to 1.15 thumbs up
Sorry, only registered users may post in this forum.

Click here to login