Welcome! Log In Create A New Profile

Controlling 2 ormerods on 1 laptop

Posted by Sardi

Sardi

Controlling 2 ormerods on 1 laptop
May 15, 2021 02:37PM

Registered: 10 years ago
Posts: 466

Is that possible?

I own an Ormerod 1 that I control via web interface on my laptop, and I have recently purchased an used Ormerod 2..

Is it possible to somehow control both of them on 1 laptop via router or something?

Reply Quote

dc42

Re: Controlling 2 ormerods on 1 laptop
May 16, 2021 02:09AM

Registered: 10 years ago
Posts: 14,672

Yes, just configure them to have different MAC addresses (M540) and different IP addresses (M552) and use 2 tabs in your browser.

Edited 1 time(s). Last edit at 05/16/2021 02:12AM by dc42.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

Sardi

Re: Controlling 2 ormerods on 1 laptop
May 16, 2021 04:43AM

Registered: 10 years ago
Posts: 466

Thanks DC, will do that as soon as I finish printing the replacement parts for the 02.

Reply Quote

Sardi

Re: Controlling 2 ormerods on 1 laptop
September 28, 2021 10:46AM

Registered: 10 years ago
Posts: 466

I have changed the MAC and IP address on my Ormerod 2, but it doesnt want to finish loading the page.

They are both connected to a router, and Im controlling Ormerod 1 without any issues, but O2 page just keeps loading.

EDIT: somehow managed to click "Connect" and get it to "Retrying" but that is as far as it goes.

Reply Quote

Sardi

Re: Controlling 2 ormerods on 1 laptop
October 02, 2021 05:18AM

Registered: 10 years ago
Posts: 466

Sorted.

Upgraded firmware to 1.18.1 and web interface to 1.15 thumbs up