Had my Smartrap for a year, been printing away quite happily, no problems no fuss.
Today I printed one part, removed it from the bed.
Set it to print the same part again, and the head goes through the self-levelling as normal, then moves to centre, as if to start printing, but then moves to x=0?
I am not getting any messages on the lcd, I have no loose wires, it has simply started doing this, and despite repeated attempts, power off, restart etc, I cannot get the printer to function again.
It's not the Gcode, I have tried other files that previously printed ok with the same result.
Here is a quick video to show what it is doing, if anyone can tell me what the problem could be I would be very grateful, I am stumped.
Smartrap problem
Cheers
Rob