I now have my jhead lite v2 and I'm trying to solder the wires cor coded but I have no clue which ones correspond with each other and where they get plugged into on the ramps.

---

Knife-Edge Designs, with Griffin Aeronautics- Check out our progress on our drones, 3d printing, and other projects on our google+ pages.

Depending on which batch you have, there should either be a piece of red tape on the heater leads, or they should be marked with a T or H. If this isn't present, than check for the thicker / longer metal part of the leads. That's your heater. Likewise you can check one set of the leads for a resistance of 6.8 ohms with a multimeter.