|
Genie MK2 Hotend November 28, 2014 10:55PM |
A number of people have asked me about the grooved nut that goes on the Genie MK2 hotend.
It can also be used on the Genie MK1 hotend if needed and is also reversible so that it has different lengths because the groove is not in the middle.
Here is a drawing of the grooved nut and also I have made an STL file for download if you want to print one out for fitting or using while designing a mount for the hotend.
STL file for grooved nut
[regpye.com.au]
"Experience is the mother of all knowledge." --Leonardo da Vinci
It can also be used on the Genie MK1 hotend if needed and is also reversible so that it has different lengths because the groove is not in the middle.
Here is a drawing of the grooved nut and also I have made an STL file for download if you want to print one out for fitting or using while designing a mount for the hotend.
STL file for grooved nut
[regpye.com.au]
"Experience is the mother of all knowledge." --Leonardo da Vinci
|
Re: Genie MK2 Hotend November 29, 2014 04:14AM |
Too late for me! I printed the smartrap X end for the MK2 yesterday evening. 
And tomorrow I will start my tests, finally. I should have the results in a week or two.
And tomorrow I will start my tests, finally. I should have the results in a week or two.
|
Re: Genie MK2 Hotend November 29, 2014 04:46AM |
Quote
cristian
Too late for me! I printed the smartrap X end for the MK2 yesterday evening.
And tomorrow I will start my tests, finally. I should have the results in a week or two.
You are really on the ball Cristian.
Looking forward to your tests and see if there is any difference between the MK1 and MK2 with what you are doing.
[regpye.com.au]
"Experience is the mother of all knowledge." --Leonardo da Vinci
Sorry, only registered users may post in this forum.