Hey all, as a number of other people have their own thread, I thought it might not be too much of a problem if I have one too.
I have a smartrap and have managed a few decent little prints. Currently I'm playing around with the OpenForge tiles, they're pretty cool [
www.thingiverse.com]
I have an issue at the moment, which perhaps people can help with. I think I'm having an issue with my bed levelling due to an element of give in the top left corner (the first levelling point). The Z lowers and presses on the bed, but the bed has about 2-4mm of give to it which I suspect is partially responsible for some problems I'm having with the prints.
Anyone else come across this?
Cheers!
millsy
