smartrapcore 100*100*100mm*3

A long due project is close to be finished. Goal was to test core-xy and to have a small (portable) printer. The printer has been testet with a birdsnest of wires :-)



And to get rid of the birsanest I added a box frame under the original for hiding all the electronics. A ramp board plus a Raspberry Pi with OctoPrint plus a powersupply.
I'm not sure about placement of the extruder. It may be moved to inside the box later.

The servo for bed levelling is a made from a simple wooden bracket.



All steppers (except extruder) is nema-14

Have fun
Niels

I like it!

wonderful

i dream of a small version here too , to put on our desks beside screens.. really great job oz9ny

---

the Smartrap project

[smartfriendz.com]
[www.thingiverse.com]
[reprap.org]
[github.com]
doc assemblage: [reprap.org]
NEW: Forum smartfriendz: [smartraptalk.smartfriendz.com]