Reprap prusa i3

Ciao ragazzi, ho montato la mia prima stampante 3d in tutta la mia vita, e fin qui tutto bene finchè non vado a fare la mia prima stampa.
Ho messo tutti i settaggi su cura piatto eccecc, e vedo che non stampa al centro ma stampa di lato sembra quasi fuori asse e non capisco il perchè è 2 giorni che sbatto la testa!
Spero che in questo forum potete aiutarmi


16:09:42.134 : Printer reset detected - initalizing
16:09:42.149 : start
16:09:42.149 : echo:Marlin1.0.0
16:09:42.149 : echo: Last Updated: Jan 4 2016 19:03:56 | Author: (John, default config)
16:09:42.149 : Compiled: Jan 4 2016
16:09:42.149 : echo: Free Memory: 3795 PlannerBufferBytes: 1232
16:09:42.149 : echo:Hardcoded Default Settings Loaded
16:09:42.149 : echoteps per unit:
16:09:42.149 : echo: M92 X78.74 Y78.74 Z2560.00 E105.00
16:09:42.149 : echo:Maximum feedrates (mm/s):
16:09:42.149 : echo: M203 X400.00 Y400.00 Z2.00 E45.00
16:09:42.149 : echo:Maximum Acceleration (mm/s2):
16:09:42.149 : echo: M201 X1400 Y1400 Z100 E80000
16:09:42.149 : echo:Acceleration: S=acceleration, T=retract acceleration
16:09:42.149 : echo: M204 S1400.00 T5000.00
16:09:42.149 : echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s)
16:09:42.149 : echo: M205 S0.00 T0.00 B20000 X13.50 Z0.30 E5.00
16:09:42.149 : echo:Home offset (mm):
16:09:42.149 : echo: M206 X0.00 Y0.00 Z0.00
16:09:42.149 : echoID settings:
16:09:42.149 : echo: M301 P19.86 I1.00 D98.93
16:09:45.587 : echoD init fail
16:09:45.649 : FIRMWARE_NAME:Marlin V1; Sprinter/grbl mashup for gen6 FIRMWARE_URL:[firmware.ultimaker.com] PROTOCOL_VERSION:1.0 MACHINE_TYPE:I3 Pro B EXTRUDER_COUNT:1 UUID:00000000-0000-0000-0000-000000000000
16:09:45.665 : X:0.00 Y:0.00 Z:0.00 E:0.00 Count X: 0.00 Y:0.00 Z:0.00
16:09:45.665 : echo:Active Extruder: 0
16:09:45.665 : Begin file list
16:09:45.665 : End file list
16:09:45.665 : echo:Active Extruder: 0

Edited 1 time(s). Last edit at 01/15/2018 10:11AM by miticoandre.