Salve
come da titolo non riesco ad inserire i valori giusti ed avere una mesh valida che attivi l'MBL
Questi sono i miei dati, per il quale funziona solo lo Zsafe home
#define X_MAX_POS 250
#define X_MIN_POS 0
#define Y_MAX_POS 210
#define Y_MIN_POS 0
#define Z_MAX_POS 200
#define Z_MIN_POS 0
#define E_MIN_POS 0
#define AXIS_RELATIVE_MODES {false, false, false, false}
#define Z_SAFE_HOMING
#define Z_SAFE_HOMING_X_POINT 35
#define Z_SAFE_HOMING_Y_POINT 10
#define MESH_BED_LEVELING
//#define AUTO_BED_LEVELING_UBL
//#define AUTO_BED_LEVELING_LINEAR
//#define AUTO_BED_LEVELING_BILINEAR
//#define AUTO_BED_LEVELING_3POINT
//#define MESH_EDIT_GFX_OVERLAY
#define MESH_INSET 5
//#define G26_MESH_VALIDATION
#define MESH_TEST_NOZZLE_SIZE 0.4 // (mm) Diameter of primary nozzle.
#define MESH_TEST_LAYER_HEIGHT 0.2 // (mm) Default layer height for the G26 Mesh Validation Tool.
#define MESH_TEST_HOTEND_TEMP 200.0 // (c) Default nozzle temperature for the G26 Mesh Validation Tool.
#define MESH_TEST_BED_TEMP 60.0 // (c) Default bed temperature for the G26 Mesh Validation Tool.
#define MESH_MIN_X (X_MIN_POS + (MESH_INSET))
#define MESH_MAX_X (X_MAX_POS - (MESH_INSET))
#define MESH_MIN_Y (Y_MIN_POS + (MESH_INSET))
#define MESH_MAX_Y (Y_MAX_POS - (MESH_INSET))
#define MESH_G28_REST_ORIGIN
#define UBL_MESH_EDIT_MOVES_Z
//#define UBL_Z_RAISE_WHEN_OFF_MESH 2.5
#define GRID_MAX_POINTS_X 3
#define GRID_MAX_POINTS_Y 3
#define LEFT_PROBE_BED_POSITION 35
#define RIGHT_PROBE_BED_POSITION 240
#define FRONT_PROBE_BED_POSITION 10
#define BACK_PROBE_BED_POSITION 220
#define MIN_PROBE_EDGE 10
//#define PROBE_Y_FIRST
//#define ABL_BILINEAR_SUBDIVISION
#define BILINEAR_SUBDIVISIONS 3
#define PROBE_PT_1_X 15
#define PROBE_PT_1_Y 180
#define PROBE_PT_2_X 15
#define PROBE_PT_2_Y 15
#define PROBE_PT_3_X 180
#define PROBE_PT_3_Y 15
//#define Z_PROBE_END_SCRIPT "G1 Z10 F8000\nG1 X10 Y10\nG1 Z0.5"
#define ENABLE_LEVELING_FADE_HEIGHT
Dove e cosa sbaglio??
