Repetier Host October 27, 2014 03:59PM |
Registered: 13 years ago Posts: 861 |
Re: Repetier Host October 28, 2014 03:32AM |
Registered: 10 years ago Posts: 199 |
Re: Repetier Host October 28, 2014 06:06AM |
Registered: 13 years ago Posts: 861 |
Re: Repetier Host October 28, 2014 08:12AM |
Registered: 10 years ago Posts: 199 |
Re: Repetier Host October 28, 2014 06:13PM |
Registered: 10 years ago Posts: 344 |
Re: Repetier Host October 29, 2014 02:53AM |
Registered: 13 years ago Posts: 861 |
Re: Repetier Host November 01, 2014 04:09PM |
Registered: 10 years ago Posts: 344 |
Quote
Replace
As this is the new Flow-Rate thread,
can anyone tell me if it is true that moving the flow rate bar during print, will only affect plastic throughput and no other stepper ?
So actually it is to get more or less plastic than defined in the firmware and by the slicer , per mm travel for that object ?
Thomas