I have created the page 'safety' [
reprap.org] on the reprap wiki. This page was formerly a redirect to the health and safety page.
Along this page, I also created board safety [
reprap.org] and electronic cooling [
reprap.org] pages, and the Safety category
I may create a page on CE certification, but I have to think a bit more about it.
I also initiated the thread '3D printer safety' in the deltabot google forum.
[
groups.google.com]
I would like to highlight this post from JolietDelta which looks me of particular interest [
groups.google.com]
Contributions to this page or comment page as needed are welcome.