Photocatalytic Filter
August 06, 2017 04:10AM
Hi,

I have read something about 3D printing related emission. Most people does not really care about it but I want to think about a pracital solution. According to this article a hepa filter is not able to remove produced nano particels.
[www.3ders.org]

They suggest to use photocatalytic filters to neutralize these particels. I was googeling around for a photocatalytic coating until I realized sunscreen often contains Titanium-Dioxide (TiO2) with the same effect. With UV light (>390nm) it becomes effective. How about coating a large-pored and high surface area object like a sponge or even a plate with TiO2/sunscreen. To its surface an UV light source is shining. Some kind of air circulation fan shall be used to clean printer's fumes.

What do you think about this? How you could measure effectiveness of such a system?
Re: Photocatalytic Filter
August 06, 2017 06:33PM
Do you filter or neutralize your:

Chimney
Plumbing vent pipe
Kitchen stove vent
auto exhaust
painting
farting

???

Are there OSHA acceptable levels on hobby 3D printing with ABS?

confused smiley
Re: Photocatalytic Filter
August 07, 2017 01:42PM
to the first part, what the hell?

As far as I know health impact from ultra fine particles is unknown. There are a safety limit for particles in cities... Maybe something like that.
Sorry, only registered users may post in this forum.

Click here to login