Hello everyone,

I'm currently using a Prusa i3 clone that I built on my own, using the RAMPS 1.4 shield.
The reset button is quite handy when something goes wrong, but at the moment is not very easy to reach (I built an enclosure and all the electronics are screwed on the bottom of the table).
Is there a way to add a custom reset button without de-soldering the current mini-button on the RAMPS?

just wire another button to the legs of the current button, no need to desolder it

When I used a ramps, I just soldered a two pin header on the bottom, sticking out the side of the reset button connections underneath to connect another one else where.

Thank you everyone!
I simply soldered the wires from the bottom of the existing button and everything's working smooth.

Thanks again!