Hi,
I am converting my D-Bot and need to have a cable chains from the base to the print gantry and from the print head to the side upright so that it fits along side the 40mm extrusion.
I have tried various designs before and found them to be loose and/or sticking when used in the side on mode.
I notice that quite a few coreXY users have cable chains and was wondering if you could share your designs and experience.
Thank you
Paul
Edited 1 time(s). Last edit at 09/22/2017 04:58AM by appjaws1.
appjaws - Core XYUV Duet Ethernet Duex5
firmware 3.1.1 Web Interface 3.1.1
Ormerod 1-converted to laser engraver, Duet wifi
OpenSCAD version 2020.07
slic3r-1.3.0, Simplify3D 4.1.2, Cura-4.4.1