Hi,
I am having a strange issue with my Hypercube and Bigtreetech SKR V1.3 board (Smoothieware).
Working on the config.txt file I was able to adjust settings for the Z-axis (direction, speed etc.).
But for unknown reasons the CoreXY mode (arm_solution) is not accepted at all.
Both motors are working but only in single mode.
When I use the touchscreen to move x-axis one motor moves, when using Y-axis the other motor is moving.
Does anyone knows if this is a bug or am I doing something wrong.
my current config file is attached.
Best regards
Onki
