Hello all,
I have been having a strange surface finish on my prints and have been posting everywhere trying to figure it out. Some guys in my duet post suggested I try here as well.
Here is a link to the duet post: [
forum.duet3d.com]
And this is what I have tried so far:
-XY stepper motors from LDO 1.8 to E3D 0.9
-Extruder from a clone BMG to a genuine Titan
-Extruder motor form a LDO 0.9 pancake to a LDO 1.8, to some random 1.8 (tried with both extruders)
-Hot end from clone to genuine V6
-Belts from whatever to genuine Gates (with pulleys)
-A BigTreeTech GTR running Marlin to the Duet 3 with updated firmware
-I've tried Cura, PrusaSlicer, and Ideamaker
-Extremes in belt tension
-Extremes in flow rate
-Bass nozzles and e3d's Nozzle X
-Print temp and bed temp very less then 1C
-Fan speed does not change anything
-I have tried hatchbox, esun, and printed solid pla
-I have tried esun and overture petg
-Temps from 190 to 230 for pla
-No the hot end does not wobble, everything is...firm. As in no play.
In addition, the frame is squared to 0.1deg using a digital protractor, and all three lead screws have been given the same treatment.
Any ideas whats going on?
Attachments:
open |
download -
IMG_20200709_183845.jpg
(144.5 KB)