corexy homing endstop help needed

hello , i am working on getting my Tronxy x5sa setup with a BTT skr 2 board with BLtouch and i cannot get the homing xy and endstops figured out it is driving me crazy ! i have edited many times my config files involving the endstops, inverted directions, and cannot get it to home correctly it is a mess i was wonder if someone could review my config H setting and help me get them corrected

Thanks
Tim

I have always thought that you must set "Z_MIN_PROBE_ENDSTOP_INVERTING" to same logic as "Z_MIN_ENDSTOP_INVERTING".

There may may a reason why it does not though I do not know of any.
Could you explain further what happens when you home your 3D printer, or better yet post a short video to a share like Google Drive.

---

Computer Programmer / Electronics Technician